Tempit Ultra-F Unit 0.20g Centrix
Form Prosthetic restoration materials
Specially designed for temporary fillings that can withstand up to one year in adults and up to 2 years in children. Just load the pre-filled unidoses into any CR® spray gun injected lightly for 40 seconds and ready. Tempit Ultra takes the shot by light curing in 40 seconds at a depth of 6mm. No mixing required. TempitUltra is packaged in unidoses ready for injection in preparations. It does not require engraving or amelo-dentin adhesives. Tempit Ultra can be applied over basic fillings desensitizing disinfectants or over substances for direct hairdressing. Tempit Ultra can be removed with the milling cutter before placing the final seal. Contains a bio-compatible resin photopolymerizable with dimethacrylate diurethane similar to the photopolymerizable resins for the base. To ensure durability and durability TempitUltra is saturated with 30% silicon dioxide. TempitUltra will not “wash”. It has higher compressive power and lower solubility than ZOE sealing materials.
It does not require mixing does not create misery
Without the risk of the appearance of marginal infiltration
The light curing takes place on a depth of 6mm
No cross contamination
For long-term temporary seals
It can be used as a permanent filling material on temporary teeth in children
No polymerization shrinkage
Very high mechanical strength
Pre-filled units for injection directly into preparations
Single use units for easy placement and without pathogenic germs
Photopolymerizable – plugs in 40 seconds or less
It does not contain eugenol to prevent allergies and does not prevent the adhesion of composite materials
A variant with flower release is also available (Tempit® Ultra-F)
Instructions for use:
Clean and disinfect the cavity. If there is an opening of the pulp chamber, plug it using calcium hydroxide (Calciject). it is advisable to use a dental desensitizer on vital teeth (D / Sense or Glu / Sense). Do not demineralize or use bonding systems
The preparation should be as dry as possible
Insert Tempit Ultra into the applicator gun. Remove the lid and inject the material into the preparation. If necessary use a matrix to restore the contour of the tooth. Model the material with conventional tools used also for the composite material. To make the material less sticky introduce the instrument with which you mold the material into alcohol or leave the Tempted Jar in the refrigerator before using
Cure for 40 seconds. ULTRA TEMPIT will make the socket on a depth of 6mm.
To adjust the tooth in the occlusion or to remove the material after making the socket use a diamond cutter or extruder. Keep material away from strong light sources. Do not store material below 4 * C
Tempit Ultra-F Unit 0.20g 1 pcs.